Ok. I’ll head down there and take a look at it and let you know. Super glue should work just fine with a little baking soda and water added to it, but I’ll check it out before I do anything to it. Take it easy and get to feeling better.

It is 3d printed. I just haven’t had much luck with superglue on pieces in the past. I don’t know if the materials were the same.

It’s 3D printed in PLA, correct?

I don’t know how well superglue holds on those pieces. I can go take care of it in a little bit if necessary.

I could go super glue it real quick. It’ll be good to go in an hour.